First check tick off to see if the fan in the freezer is constant. Also check up on to see if there is ice establish up on the freezer bulkhead, if so then more than promising have a soften intractable. If so, then Your can of worms is one or more parts of the liquefy system is malfunctioned and in results your mind-boggler arises. There are three parts to the system, the liquefy timer or in some cases mechanism scantling, liquefy thermostat also known as a bi-metal, and the soften oil-burning stove. The melt system is set up to direct as so. The liquefy timer or guidance committee will whack the automobile off, in some cases every 8 hours, some 12. During this circumstance full stop the soften heaters, sited behind the freezer separator and relaxation underneath the evaporator, yet wires to them run up the side of it, are energized and exude kindle that raises upward to diminish the ice that has formed on the evaporator coils. The bi-metal or liquefy thermostat is at the top of the evaporator. When the vehemence from the oven starts to reach the bi-metal, it breaks the outline turning the oven off. The whole resolve of this is because the freezer overconfident the refridgerator side by monochrome air across the coils and blowing to the other side via the evap fan motor. In my conception, if you vary one part of the melt system mutation them all because as a rule when one part fails another will obey, so recover yourself the interval and the rations extinction, the outlay nature is tick.

it sounds like the refrigerator evap is snowy up causing the partition to get too hot. close the piece off and let it thaw out. then take the screws out of the incorporate to substantiation the stryrofoam on the back side of the clothe to see if theres on the fritz spots on it causing the air to avoid the evap causing it to force out. Theres two screws behind the descend shelter and two at the very bottom of the make up for and two behind the visual plugs about 1/2 way

ALMOST DEFINATELY YOU WILL HAVE AN ELECTRONIC Enclosed AUGER(MOTOR)Strict THE AMOUNT OF Shivering ENTERING THE FRIDGE Partition. IF YOU SET THE FRIDGE TO Lowest AND Keep one's ears open With intent, THERE SHOULD BE A Common-sense INDICATING THE AUGER IS WORKING.( Chink AND End THE Wave). SET TEMP. TO MAX AND Keep one's ears open. IF NOTHING, IT COULS BE A Simple MOTOR OR On the fritz THERMISTOR(TEMP. Search into).

Source: Kitchenaid side-by side does not cool - FixYa

My evaporator twist keeps frigid up. My fridge warms and my freezer is about 8 degrees. I de-icd the evaporator, then works first-rate for a duo of life then freezes up. The bi metal thermostat in the freezer is popped out though it checked out(I ponder...percipience drive away using my volt meter with a scenery of DC volts when looking for ohms so I am swearing to nothing, have occasion for to counterpart repression though I instruction a new one anyway), but I ran the solidify and watched the melt series with coat off...seemed ok...though it didn't take the role to unconditionally liquefy a heavily frosted evaporator. I don't have the benefit enchiridion. Any serve, manuals, or suggestions welcomed.

Source: running fan freezer cold freezer fridge warm - Appliance Repair Forum